Installation - GE NX-320E Installation Manual

Installation

There are several two-holed insertion points inside the enclosure so you can install the module either
horizontally or vertically. The insertion points have a large hole and a smaller hole.
To mount the board in an enclosure, see Figure 1 and do the following:
1. Place a black plastic PCB guide in the top insertion point, grooved edge downward. The half-moon
protrusion will be in the large hole. Do not use excessive force.
2. Insert one of the included screws into the smaller hole (from the inside of the can) to secure it in place.
A screwdriver should reach through the notch that runs the length of the guide to tighten the screw.
3. Position the other PCB guide opposite the first (grooved edge up) and placed in the lower insertion
point, using the same procedure. Once you mount the guide, screw it in securely.
4. Slide the board into the grooves of both guides. The PC board should slide freely.
Figure 1. Board installation
3