Leds; Enrolling - GE NX-320E Installation Manual

8 NX-320E Remote Power Supply
Installation Manual

LEDs

The power supply module has four red LEDs to provide status information. See Figure 2 and Table 5 for
locations and descriptions of the LEDs.
Table 5. LED connections
LED Board ID
LED 1 DS1
LED 2 DS2
LED 3 DS3
LED 4 DS4

Enrolling

The NetworX control panel can locate and store the presence of keypads, zone expanders, and wireless
receivers, and other modules connected to the data terminal. This allows these modules to be supervised by the
control panel. To enroll the modules, enter NetworX control panel program mode and then exit program mode.
The panel automatically enrolls the devices. The process takes about 12 seconds. During this time, the Service
LED illuminates and you cannot enter user codes. If you enroll a module that the system cannot detect, the
Service LED will illuminate.
Description
Flashes when data is transmitted from the NX-320E.
Flashes when data is transmitted into the NX-320E.
Flashes during normal operation.
Glows dimly when connected to the NetworX panel. (See Specifications on page 19).