Programming Locations - GE NX-320E Installation Manual

Programming locations

Location 0 - event and time for output A. This location has two segments of numerical data. To
program the event and time set the following:
• Segment 1. Select the event that triggers Output A. See Table 6 for events you can trigger.
• Segment 2. Select how long an output will remain activated when an output triggers. For a location
that is programmed as zero, the output will follow the event.
Table 6. Event and time programming for Output A
# Event
0 Always on
1 AC fail (control or exp.)
2 Low battery (control or exp.)
3 Dynamic battery test time
4 Listen in
5 Line seizure
6 Telephone line fault
7 Program mode
8 Overcurrent (control or exp.)
9 Box tamper (control or exp.)
10 Siren tamper (control or exp.)
a. Does not follow AC fail delay time.
b. If set to the following condition, these events will be one second.
# Event
11 Smoke power reset
a 12 Yelping siren
13 Steady siren
14 Any siren
15 Steady siren (temporal)
16 Any siren (temporal)
17 Alarm memory
18 Entry
19 Exit
20 Entry or exit
21 Armed
# Event
22 Disarmed
23 Ready to arm
24 Not ready to arm
25 Fire
26 Fire trouble
27 Chime
28 Beeping keypad
29 Aux 1 keypad function
b
30 b Aux 2 keypad function
31 Panic keypad function
b
32 b Code entry (set in loc 8–17)
11