Installation Instructions - GE RAK315D Installation Instructions Manual

ZONELINE SERIES – DIRECT ELECTRICAL CONNECTION
It is the responsibility of the installer to ensure the connection of components is done in accordance with the NEC,
Direct connection to branch circuit wiring inside the junction box must be made by connecting as follows.
This kit must be used in conjunction with a GE
RAK4002D junction box kit. Order this kit separately.
1. REMOVE ROOM FRONT
Remove the room cabinet by pulling it out at the bottom to
release it (1); then lift it up to clear the rail along the unit
top (2)
2. REMOVE JUNCTION BOX COVER
Remove the junction box cover by removing the screw
holding it to the assembly.
Junction box
cover
Screw

Installation Instructions

local codes, ordinances and regulations.
Recommended branch circuit wire sizes*
Nameplate maximum circuit breaker size
15A
20A
30A
AWG—American Wire Gauge
* Single circuit breaker from main box
** Based on copper wire, single-insulated conductor at 60°C
For GE Zoneline AZ45 & AZ65 Series Units
Junction box
Knock out
AWG wire size**
14
12
10
3. INSTALL JUNCTION BOX
(230/208V units)
Install the junction box by engaging the left tabs of
the junction box with the slots on the control housing,
align the screw hole at the top and drive the screw until
secure.
4. CONNECT THE CORDSET
Plug the connectors, provided in the Direct Connect Kit,
fully into place in the corresponding mating connectors.
Be sure the locking tabs at the sides are engaged.
15A
Power supply kit -
NOTE: RAK315D and RAK515D will only have
one power connector.
For a direct connect kit installation with a flex cable,
proceed to step 5A.
For a direct connect kit installation with a sub-base and
chaseway, skip ahead to step 5B.
2
Slots on
Control
Housing
Tabs on
Junction
Box
20A and 30A
Appearance may vary