Chapter 2 Installation And Connections; Nvr Installation; Hard Disk Installation - HIKVISION DS-7604NI-Q1 Quick Start Manual

Chapter 2 Installation and Connections

2.1 NVR Installation

During installation of the NVR:
 Use brackets for rack mounting.
 Ensure ample room for audio and video cables.
 When routing cables, ensure that the bend radius of the cables are no less than five times than
its diameter.
 Connect the alarm cable.
 Allow at least 2cm (≈0.75-inch) of space between racks mounted devices.
 Ensure the NVR is grounded.
 Environmental temperature should be within the range of -10 to +55º C, +14 to +131º F.
 Environmental humidity should be within the range of 10% to 90%.

2.2 Hard Disk Installation

Before you start:
Disconnect the power from the NVR before installing a hard disk drive (HDD). A factory
recommended HDD should be used for this installation.
Tools Required: Screwdriver.
Step 1 Remove the cover from the NVR by unfastening the screws on the rear and side panel.
Step 2 Connect one end of the data cable to the motherboard of NVR and the other end to the
HDD.
Network Video Recorder Quick Start Guide
Figure 2-1 Remove Cover
13