Advertisement
4.
Secure end frames and upper supports
with (4) external corner braces and (4) internal
corner braces, using (12) M8-1.25 x 55 but-
ton head cap screws, (24) 8mm flat washers,
and (12) M8-1.25 lock nuts (see Figure 6).
DO NOT fully tighten fasteners yet.
x 12
End Frame
Upper Back
Support
Figure 6. End frame and upper back support
secured together with corner braces.
5.
Secure end frames and lower support with
(2) external corner braces and (2) internal
corner braces, using (6)M8-1.25 x 55 button
head cap screws, (12) 8mm flat washers, and
(6) M8-1.25 lock nuts (see Figure7). DO NOT
fully tighten fasteners.
External
Corner
Brace
Lower
Support
End Frame
Figure 7. End frame and lower support secured
together with corner braces.
Model T1251 (Mfd. Since 11/17)
6.
External
Corner
Brace
Internal
Corner
Brace
7.
8.
9.
10. Remove (6)
x 6
Internal
Corner
Brace
Thread rubber feet into bottoms of end
frames (see Figure 8).
Figure 8. Rubber foot threaded into bottom of
end frame.
Turn workbench upright. Make sure it is
centered over end frames and supports (not
leaning to one side or the other), then fully
tighten all fasteners.
Adjust feet as necessary to ensure work-
bench sits firmly on ground and does not
rock.
Option: Lay a level across workbench from
side-to-side and end-to-end when adjusting
feet.
Select two attachment locations to install
vises.
Tip: Consider full-range of vise movement
and workbench position when selecting
attachment locations for vises.
⁄
"-16 hex nuts from (4) sleeves
7
8
and (2) threaded sleeves.
Rubber
Foot
End Frame
-3-
Advertisement
