Table of Contents
Advertisement
Pos: 1 3 /Über schriften/ 1.1/Standortwahl @ 1 5\mod_ 1102 59117 9197_ 18.docx @ 1 23412 @ 2 @ 1
1.6
Installation site
Pos: 1 4 /Sicher heit/Standort/Termotek - Schr off-Kühler @ 158\ mod_1 37361 8767 274_1 8.docx @ 160 5212 @ @ 1
Pos: 1 5.1 /Ü bers chrifte n/1.1 /Sicher heitshinw eise zum Transport @ 1 5\ mod_ 1106 23522 9266 _18.docx @ 1 3328 4 @ 2 @ 1
1.7
Safety instructions for transport
Pos: 1 5.2 /Ü bers chrifte n/1.1. 1/Allgemei n @ 15 \mod_1 1053 56965 484_1 8.docx @ 12 8601 @ 3 @ 1
1.7.1
General information
Pos: 1 5.3 /Sicherheit/Transport/ Warnung - Verletzungsge fahr dur ch unsa chge mäße n Trans port @ 22 2\mod_ 14135 3945 3644_ 18.docx @ 2 09963 1 @ @ 1
Pos: 1 5.4 /Hinw eise/Vorsi cht / Achtung - GerätAchtung - Bes chädig ung dur ch unsa chge mäße n Trans port 4 Pkt. @ 16 6\mod_ 13813 0041 2030_ 18.docx @ 1 65971 7 @ @ 1
Pos: 1 6 /Hinweis e/Warnung Per sonenWar nung - Kippgefa hr (s chmales Gerät ) @ 190 \mod_1 3966 07317 081_ 18.docx @ 19 0473 9 @ @ 1
Pos: 1 7 /-- leer --/=== ===== @ 1\mod2 6_18. docx @ 2718 8 @ @ 1
Safety
When selecting an installation site, observe the following instructions:
•
Keep the specified escape routes clear.
•
Ensure firm support and a horizontal position of the unit.
•
Comply with the data stated in the "Technical Data" section concerning the
ambient temperature for operation, transport, and storage when the unit is
completely empty.
•
Ensure sufficient space for operating, maintaining, and cleaning the unit.
•
Keep the air inlets and outlets free.
Comply with the relevant technical and building regulations.
Lay the hoses and electrical cables so that there is no danger of tripping and that they are
protected from damage.
When selecting an installation site, the applicable safety regulations and manufacturer
instructions concerning any substances that are used for, or located near, the machine
must be observed.
WARNING
Danger for persons!
Increased risk of injuries through improper transport.
The transport of the unit should be carried out only by suitably qualified persons who are
familiar with the unit and who have been informed as to potential hazards.
Notice
Damaging of unit!
Damage due to improper transport.
•
Make sure to follow signs (if attached) at unit when transporting unit.
•
Transport units with suitable lifting gear only.
•
Transport the unit only when it is empty.
•
Transport on suitable and secured transporting pallet.
WARNING
Danger of overturning!
Due to the slim set-up of the unit, there is a higher risk of injury when the unit tips over.
Ensure that the unit is sufficiently secured during the transport.
VARISTAR Cooling unit SHX 30
9
Advertisement
Table of Contents
