Enroll The Second Or Additional Fingerprints And Bound Code; Set/Change The First Code; Enroll The Second Or Additional Codes; Disable / Enable User - Securam ScanLogic Optical Operating Instructions Manual

In Security Level 2, the system will guide you through the fingerprint enrollment process
immediately followed by the code setting process.
Place your finger on the fingerprint reader window and hold.
The first fingerprint with an ID No. 01 is enrolled.
Enter a code (10 digits).
Enter the same code again.
When the screen shows "ID 01 Code Saved", the first fingerprint and its bound code with
ID No. 01 are enrolled successfully.
Note: The default password (1234567890) will be deleted automatically after the first
fingerprint and code are enrolled successfully.
22. Enroll the second or additional fingerprints and bound code (Level 2)
Unlock with an administrator's fingerprint and code .When the LCD screen shows "Select
Menu", press "▲" or "▼" to select Enroll New User.
Follow the same steps as to enroll the first administrator's fingerprint and code to
complete the enrollment.
23. Set/Change the first code (Level 1)
Unlock with the default code (1234567890). When the LCD screen shows "Select Menu",
Press "▲" or "▼" to select "Set/Change User Code", enter the 10-digit new code.
Note: Follow the same steps to change any valid code.
24. Enroll the second or additional codes (Level 1)
Unlock with the code of ID 01, When the LCD screen shows "Select Menu", press "▲" or
"▼" to select "Enroll New User" , Press "▲" or "▼" to select ID No. and set new codes .
25. Disable / Enable User (Level 1 & 2)
Unlock by an administrator (ID 01 or ID 02) .When the LCD screen shows "Select Menu",
Follow the steps on Pages 6-7 to disable or enable a user.
26. Set time delay (Level 1 & 2)
SecuRam Systems Inc. Page 14