Securam ScanLogic Optical Operating Instructions Manual page 2

Important:
For indoor use only.
●
● Use one 9V alkaline battery. Manufacturer recommends to use Duracell
®
Energizer Alkaline batteries.
Always use an alkaline battery for high quality performance.
● Battery Low Voltage: 5.4 ± 0.2V. The display will alert low battery when battery voltage
reaches 5.4±0.2V. PLEASE REPLACE THE BATTERY IMMEDIATELY.
Note: The voltage is checked during fingerprint verification. If the battery is low, nearing
5.4±0.2V, the EntryPad will not allow functions other than unlock. (Operations, such as
enrolling, deleting or time-delay setting, are not permitted until the battery is changed).
Security level classification
Level 1: EntryPad can be operated by a code.
Level 2: EntryPad must be operated by a fingerprint and its bound code.
Level 3: EntryPad must be operated by a fingerprint or a code.
Note: Factory default security level is Level 3.
For safety and security, all codes will be automatically deleted when security level is
changed. ID No. 01 code will be default code 1234567890.
As is the case with all biometric safe locks, the UL listing requires operation in Security
Level 2 only.
Battery Replacement Instructions
1) In the back of EntryPad you will see one 9 V alkaline battery. Take the battery out of the
battery compartment. Gently pull on the battery until it drops out.
2) Gently remove the connector by unsnapping it from the two terminals on the top of the
battery.
Never Pull on the Battery Leads.
3) Connect a new 9 V alkaline battery to the battery clip.
4) Put the battery and the leads completely back into the battery compartment.
For installation and wiring refer to the installation instructions.
About Default Codes:
The ScanLogic Optical has 1 default code 1234567890. However upon enrollment and use
of the first fingerprint (ID01), this default code is deleted. It is important to set a new code
relative to this fingerprint.
SecuRam Systems Inc.
TM
or
Page 2