Set Security Level; Enroll The First Fingerprint And Its Bound Code - Securam ScanLogic Optical Operating Instructions Manual

The EntryPad is shut down and no operation is permitted.
Then, the EntryPad will start counting down with the LCD flashing the remaining time
every 15 seconds. For example:
After the count down is finished, the EntryPad is ready to use again.
Note: Two more consecutive invalid codes will restart an additional 4 minutes delay
period. An attempt to unlock by an enrolled fingerprint will not terminate the delay period.
Incorrect fingerprint entries will not initiate penalty time.

20. Set Security Level

The ScanLogic Optical has 3 security modes as follows:
Level 1: EntryPad can be operated by a code.
Level 2: EntryPad must be operated by a fingerprint and its bound code.
Level 3: EntryPad must be operated by a fingerprint or a code.
Unlock with an administrator's fingerprint (ID No. 01 or 02). When the LCD screen shows
"Select Menu", press "▲" or "▼" to select the security level you require.
For example, to set the Security Level to Level 2, find and select Security Level 2.
Press "Menu/OK"
▪▪▪▪▪▪
Follow the same steps to set to Level 1.
Note:
After Security Level is changed, the number of locks will not be changed.
When security level is changed, all fingerprints and codes will be deleted.
The code of ID No.01 will be 1234567890.
21. Enroll the first fingerprint and its bound code (Level 2)
SecuRam Systems Inc. Page 13