Time Delay - Unlock With An Enrolled Fingerprint - Securam ScanLogic Optical Operating Instructions Manual

The system will now prompt you to enter the Time Window value (in minutes)
Press "▲" or "▼" to select Time Window (01 to 15 min).
Press "Menu/OK".
The Time Delay feature has now been set successfully.
Notes related to Time Delay operations:
During Time Delay period, programming operations (such as enrolling, deleting users

etc.) can be accomplished. The lock however will remain locked.
Time Delay Override:

codes can be used to override the time delay and gain access immediately.
After the original time delay is re-programmed, the new time delay setting will go into

effect after the first successful unlock cycle.
13. Time Delay - Unlock with an enrolled fingerprint (Level 3)
In order to unlock a safe lock that has been programmed with Time Delay, follow these
steps:
Place an enrolled finger on the fingerprint reader to verify.

The fingerprint will be verified and then the LCD will display "Time Delay Start"

For example:
Time Delay is set 10 minutes and Time Window 5 minutes.
 Place an enrolled finger (ID: 03) on the fingerprint reader window and hold until
the LCD shows:
The EntryPad will start counting up.

The LCD screen flashes with the elapsed time every 15 seconds.

When Time Delay finishes counting, two beeps will sound and the LCD screen

will show:
The EntryPad will start counting down.

The LCD screen flashes with remaining time every 15 seconds.

 Since the Time Window has been set as 5 minutes in this example, a valid
SecuRam Systems Inc.
User ID01 and 02 are Time Delay Override Codes. These
Page 9