Time Delay - Unlock With A User Code; Set Number Of Locks - Securam ScanLogic Optical Operating Instructions Manual

fingerprint or code must be presented during the 5 minute Time Window to unlock
the EntryPad.
The LCD will display:

 If an enrolled fingerprint is not presented and verified during the Time Window
period, the safe lock will remain locked. The Time Window will continue to
countdown and until the end, and then the LCD will show:
Note:
User ID01 and 02 are Time Delay Overide (TDO) codes. This means that these Users
can bypass or override any Time Delay settings, and the lock will open immediately..
14. Time Delay - Unlock with a User Code (Level 3)
Follow the same procedure as above, but instead of presenting an enrolled fingerprint
enter a valid User code. Remember to press the button marked "Code" to indicate that
you will be entering a code
15. Set number of locks (Level 3)
Unlock with an administrator's fingerprint (ID No. 01 or 02).When the LCD shows "Select
Menu", press "▲" or "▼" to select "Set number of locks".
Press "Menu/OK".
Enter Mfc. code. 9316961396
Press "▲" or "▼" to set number of locks.
The default number of lock is 01.
If setting the number of locks to be 02, 03 or 04, after the EntryPad verifies user
1 "
successfully, push "
2
unlock Lock 3, or push "
If setting the number of locks to be 01, after the EntryPad verifies user successfully, the
SecuRam Systems Inc.
to unlock Lock 1, or push "
9 "
to unlock Lock 4.
0
3 "
to unlock Lock 2, or push "
45
6 "
to
78
Page 10