SOMFY WIREFREE LT-30RT Quick Programming Manual

QUICK PROGRAMMING GUIDE FOR ALL RTS MOTORS
WIREFREE ROLL UP LT-30RT Round Head and CORD LIFT CT-32 MOTORS
Before you begin
Motors are shipped without limit settings and transmitter ID's.
Steps 1 to 7 must be completed to ensure proper shade programming and functionality.
It is recommended to power only the motor being programmed (disconnect power to all the other motors)
Motor will exit programming mode after 2 minutes of inactivity.
STEP 2: Initiate programming
Press both and
same time until the motor
jogs.
A jog is a brief up and down motion A jog is a brief up and down motion
In programming mode the
motor operates in momentary
fashion.
STEP 5: Set the limits
Press both (stop) and
at the same time until the
motor moves, then release.
The motor will stop at the
original upper limit.
Press both
Adjust to a new lower limit position.
Press both
Adjust to a new upper limit position.
Setting
Send the shade and stop it at
the desired intermediate
position by pressing
Once the desired Intermediate
position is reached, Press and
hold (stop) until the shade
jogs. The Intermediate position
is now added to memory
TM
Please refer to individual instructions for more details
Programming Mode
STEP 3: Check directions
at the Press
When pressing
should go down or out.
To change direction press and
hold
motor jogs
down movement)
STEP 6: Confirm limit settings
Press and hold
the motor jogs to confirm the
limit settings.
Adjusting the limits in User Mode
To change the lower limit
Send the motor to it's current lower limit.
and at the same time until the motor jogs
To change the upper limit
Send the motor to it's current upper limit.
and at the same time until the motor jogs.
Setting an Intermediate Position
Using
Send the shade to the
intermediate position by
(stop) pressing
shade position..
Note: Shade should be
stationary prior to activating
intermediate position
function.
or
product
(stop) until the
(shade has a short up and
(stop) until
Press until the motor jogs
Press until the motor jogs
Note
If shade is actively moving (in-motion)
(stop) from ANY
To Delete: Activate shade to intermediate
position, then press and hold
for 5 seconds. Shade will jog to confirm
deletion.
STEP 1: Connect power
With the motor installed in shade
connect power to the motor
(120V, or 12 V or 24V transformer
or 12 V battery wand)
STEP 4: Set the limits
Bring the motor to desired
upper limit. Press both
(stop) and until the
motor moves, then release.
(If
the motor stops when the buttons are
released take it back to the upper limit
Stop the motor when
and repeat)
reaching the desired lower
limit. You can adjust by
pressing or
STEP 7: Set user mode
Press and hold the
programming button on the
back of the transmitter until
the motor jogs. It will now
operate in a maintained
fashion (user mode).
Double check limit settings as
a precaution.
Should be pressed twice.
(stop)