SOMFY RAINER MAESTRIA 50 RTS Quick Programming Manual

Download this manual

QUICK PROGRAMMING GUIDE FOR

50mm motor diameter

FACTORY MODE

BEFORE YOU BEGIN

Motors are shipped in FACTORY MODE without limit settings and the

transmitter ID's. Power must ONLY be connected to current screen

being programmed. All other screens must be disconnected from their

respective power while programming.

Note - If motor is 120V AC hardwired and cannot be disconnected,

please contact an electrician prior to calling Somfy customer service

for assistance.

CONNECT TO POWER MODE

With the motor installed in the screen, connect power to the motor (120V AC).

While programming, screens should not be inactive for longer than 2 minutes

or motor will exit PROGRAMMING MODE.

INITIATE PROGRAMMING

On the transmitter, press and hold both UP and DOWN

simultaneously until the screen jogs.

CHECK THE DIRECTION OF OPERATION

If hand-held transmitter direction is not properly programmed,

Eolis/Soliris RTS sensor will not function in the manner it was

intended. Damage to the screens and injury may occur as a result.

Check the direction of rotation by pressing UP or DOWN.

If necessary change the direction of rotation by simply

pressing and holding the MY button until the screen jogs.

MAESTRIA™ 50 RTS MOTORS

MAESTRIA™ 50 RTS

MOTORIZATION FOR EXTERIOR SCREENS

Side View

Page 1 All other screens must be disconnected from their respective power while programming. Note - If motor is 120V AC hardwired and cannot be disconnected, please contact an electrician prior to calling Somfy customer service for assistance. CONNECT TO POWER MODE With the motor installed in the screen, connect power to the motor (120V AC).
Page 2 QUICK PROGRAMMING GUIDE FOR MAESTRIA™ 50 RTS MOTORS PROGRAMMING MODE MANUAL ADJUSTMENT OF THE UPPER END LIMIT AND THE LOWER END LIMIT 1) Position the screen at the desired UPPER Limit 2) Press MY and DOWN simultaneously: the screen lowers. 3) Position the screen at the desired LOWER Limit.
Page 3 QUICK PROGRAMMING GUIDE FOR MAESTRIA™ 50 RTS MOTORS OBSTACLE DETECTION CHOICE OF THE LEVEL OF DETECTION This function gives the possibility to adjust the obstacle detection during the downward movement to deactivate it or adjust the sensitivity. 1) Starting from the screen in half-way position, press MY and UP brieﬂy and again MY and UP for 2 seconds.