SOMFY R28 Programming Instructions

R28 Programming Instructions
Note: These instructions start as if the shade has never been
programmed. If the shade has been previously programmed, or
needs to go back to factory default (so you can start from the
beginning) please follow the reset directions at the bottom of the
page, before starting the programming instructions.
Disconnect power to all shades except the one
you are programming. Program one shade at
a time.
1. After connecting the battery to the shade, select the desired
channel then press the up & down buttons together (the shade
will jog).
2. Use the arrow buttons to check the direction of movement
(make sure up is up and down is down).
3. If the directions are not correct (backwards) press and hold
the "my" button until the shade jogs. Test the shade again
with the arrows; it should be correct at this point.
4. Use the up arrow to move the shade into the up position.
(Limits can be set in any order). When this position has
been reached, move on to the next step.
5. Press and hold the "my" button and the down arrow together.
When the shade begins to move, release the buttons. ( You
will need to stop the shade with the "my" button and do the
final adjustments with the arrow buttons.)
6. Once the desired down limit has been reached, press the
"my" button and the up arrow together. When the shade
begins to move, release the buttons and the shade will
continue to go up until it reaches the upper limit.