SOMFY Altus Visual Reference Manual

Altus 6 Step Visual Reference Guide
Remain clear of moving products when performing these operations.
STEP 1
Initiate programming by pressing
both the UP and DOWN
at the same time until the motor jogs. *
NOTE: After every command the motor will jog
to confirm.
STEP 3
Bring the motor to your desired upper
limit. Press and hold the MY
DOWN buttons until the motor moves
DOWN, then release. Stop the motor where
the LOWER limit should be set, you can
adjust by pressing the
For larger units, set limit at ½ down or out
position initially. Finalize programming and
allow motor to rest for 10 minutes. Then
follow steps below to adjust to final outer
limit.
STEP 5
Press and hold the MY my
the shade jogs to confirm the limit setting.
*Jog - Brief back and forth or up and down movement from the motor.
my
my
Programming
Button
my
© SOMFY SYSTEMS, INC.
11/2013
my
buttons
and
my
my
or buttons.
my
(stop) button until
To Adjust Limits
To change a limit: Move the motor to its current limit position to be changed and let it stop. Press the
UP and DOWN buttons simultaneously until the motor jogs, then release. Adjust to a new limit
position. Press the MY (stop) button until the motor jogs, then release. Check the new limit.
To add a remote/channel or sun or wind sensor: First select the remote/channel that is already
programmed to the motor and press the program button on the back until the motor jogs. Then select the
remote/channel/sun or wind sensor that you would like to add and press the program button on that
until the motor jogs.
To reset a previously programmed motor: you will need to disconnect power (120V AC) for 2 seconds,
reconnect for 10 seconds, disconnect for another 2 seconds and reconnect. The motor should start to
move/jog and then stop on its own (if this does not happen, continue to perform the disconnects until
it does). Once the motor stops, press and hold the programming button on the back of the remote and
count to ten without letting go. The motor should jog twice.
If using a multi-channel remote, begin by selecting channel to be changed.
Please contact SOMFY at 877-22SOMFY or www.somfypro.com
STEP 2
Check the direction of operation. Press and
hold the DOWN button and confirm it
moves the motor down or out (the motor
will be in momentary mode). To change
the direction, press and hold the MY
(stop) button until the motor jogs.
STEP 4
Press and hold the MY
my
buttons until the motor starts to move up,
then release. The motor will stop at the
original upper point.
STEP 6
Press and hold the Program button on the
back of the transmitter until the motor jogs.
It will now operate in a maintained fashion.
Double check the limits as a precaution.
for detailed installation instructions.
S-0027
my
my
(stop) and UP
my
Programming
Button
my