Advertisement
Quick Links
QUICK PROGRAMMING GUIDE FOR RTS MOTORS
FOR THE FOLLOWING:
●
Cl32 CORD LIFT WIREFREE™
●
R28 ROLL UP WIREFREE™
●
ST30 SONESSE® 30
●
ST40 SONESSE® 40
FACTORY MODE
BEFORE YOU BEGIN
Motors are shipped in FACTORY MODE without limit settings and
transmitter Id's. Power must ONLY be connected to current window
covering being programmed. All other window coverings must be
disconnected from their respective power while programming.
Note - If motor is 120V AC hardwired and cannot be disconnected,
please contact an electrician prior to calling Somfy customer service
for assistance.
CONNECT TO POWER MODE
With the motor installed in window covering, connect power to the
motor (120V AC, or 12V DC or 24V DC transformer or 12V battery wand).
PROGRAMMING MODE
While programming, window covering should not be inactive for
longer than 2 minutes or motor will exit PROGRAMMING MODE.
Initiate Programming
On the transmitter, press and hold both the UP
DOWN
jogs. A jog is a brief up and down or in and out motion. In
PROGRAMMING MODE, the window covering will move only
when the
simultaneously until the window covering
UP or DOWN
●
ALTUS 40
●
ST50 SONESSE® 50
●
ALTUS 50
●
ALTUS 60
is held (or momentary fashion).
38
and
Advertisement
Related Manuals for SOMFY Cl32 CORD LIFT WIREFREE
Summary of Contents for SOMFY Cl32 CORD LIFT WIREFREE
- Page 1 All other window coverings must be disconnected from their respective power while programming. Note - If motor is 120V AC hardwired and cannot be disconnected, please contact an electrician prior to calling Somfy customer service for assistance. CONNECT TO POWER MODE With the motor installed in window covering, connect power to the motor (120V AC, or 12V DC or 24V DC transformer or 12V battery wand).
-
Page 2: Setting Limits
QUICK PROGRAMMING GUIDE FOR RTS MOTORS CHECK THE DIRECTION OF OPERATION If hand-held transmitter direction is not properly programmed, Eolis/Soliris RTS sensor will not function in the manner it was intended. Damage to motorized window covering and injury may occur as a result. During installation, it is mandatory to test and verify the motorized window covering operates in accordance to the commands from hand-held transmitter. -
Page 3: User Mode
QUICK PROGRAMMING GUIDE FOR RTS MOTORS Programming Completed STEP 4: Press and hold the PROGRAMMING BUTTON on the back of the transmitter until the window covering jogs. The window covering is now in USER MODE. In USER MODE, the window covering will operate by briefly pressing the UP or DOWN (or maintained fashion). - Page 4 QUICK PROGRAMMING GUIDE FOR RTS MOTORS Activating the “MY” Position Send the window covering to the “my” position by pressing (STOP) from ANY window covering position. Window covering should be stationary prior to activating “my” position function. If window covering is actively moving (in-motion) (STOP) should be pressed twice.
- Page 5 MODE). Motor limits will need to be reestablished. Please return back to PROGRAMMING MODE to initiate programming process. CL32 Cord Lift WireFree RTS Motors Using a paperclip, press and hold the PROGRAM BUTTON, located on the back side of the motor casing until window covering jogs 3 times, then release button.
- Page 6 QUICK PROGRAMMING GUIDE FOR RTS MOTORS RESETTING ALTUS RTS 110V AC Perform a Dual Power Cut to delete all previous settings and return motor to FACTORY MODE. Step 1 Step 2 Remove plug from Plug in power cord for power for 2 seconds. 10 seconds.
Need help?
Do you have a question about the Cl32 CORD LIFT WIREFREE and is the answer not in the manual?
Questions and answers