SOMFY Sonesse 30 RTS 24V DC Quick Programming Manual

Sonesse 30 RTS 24V DC
®
Quick Programming Guide
SAFETY
• Before installation, check that this product is compatible with the associated equipments and acces sories.
• Moreover, the installer must comply with current standards and legislation in the country in which the product is being installed, and inform his customers of the
operating and maintenance conditions for the product.
IMPORTANT: Upper and lower limits are set at the factory. In the event limit setting is required, please follow steps under INITIAL PROGRAMMING AND LIMIT SETTING.
TO FINISH PROGRAMMING:
1) Supply power to the motor (see example under WIRING). The LED on the motor will flash Orange twice (repeating every 10 seconds)
2) Choose the transmitter you wish to control the shade and choose the appropriate channel for control.
3) PRESS & HOLD the UP and DOWN buttons on the transmitter until the shade jogs once.
4) BRIEFLY PRESS the PROGRAMMING BUTTON on the transmitter to pair the control to the motor. The motor will jog once.
The LED on the motor will flash Green 5 times then stop flashing.
The control is now paired to the motor.
WIRING
Connect the power cable to the motor.
INITIAL PROGRAMMING AND LIMIT SETTING
NOTE: Motor will exit programming mode after 2 minutes of inactivity. Prior to confirming limits, the shade only operates when the UP or DOWN buttons are continuously
pressed. Releasing the buttons stops the shade.
Step 1: Step 2:
Supply power
PRESS & HOLD both the
to motor.
UP and DOWN buttons at the
same time until the shade jogs.
Step 4:
Bring the shade to your desired upper
limit. PRESS & HOLD both the MY/ STOP and
DOWN buttons until the shade begins to move
down, then release. Stop the shade at the
desired lower limit, adjust by pressing the UP
or DOWN buttons.
Copyright © Somfy SAS
Step 3:
To initiate programming
operation. Press the DOWN button
and confirm the shade lowers.
Step 5:
PRESS & HOLD the UP
and MY/STOP buttons until the shade
begins to move up. The shade will
stop at the original upper limit.
www.somfysystems.com
If the shade raises instead of lowering, change the direction
Check the direction of
- PRESS & HOLD the MY/STOP button until the shade jogs.
Confirm correct direction of operation before proceeding.

Step 6:
PRESS &
HOLD the MY/STOP
button until the shade
jogs to confirm both limit
settings.
Programming

Step 7:
To finalize BRIEFLY PRESS the
PROG button on the back of the remote.
The shade will jog and will now operate
in user mode. A brief press of the UP or
DOWN button will send the shade to the
respective limit.
Programming
Button
Button