Removal Of The Din Rail; Default Position Of Din Holder - Advantech SmartFlex SR307 User Manual

– The length of the bunch (combination of power supply and data cables) should be a
maximum 1.5 m. If the length of data cables exceeds 1.5 m or if the cable is leading
towards the switchboard, we recommend installing surge protectors.
– Data cables must not have a reticular tension of
Sufficient space must be left between individual connectors for the handling of cables,
To ensure correct functioning of the router we recommend the use of an earth-bonding
distribution frame for the grounding of the power supply of the router, data cables and
antenna within the switchboard.

5.6 Removal of the DIN rail

The DIN holder is suitable for a DIN rail according to EN 60715 standard only. The default
position of of plastic or metal holder, which is used for mounting the router on a DIN rail, is
shown in the following figure:
In order to remove the DIN rail it is necessary to lightly push the router upward so that the
top part of the DIN holder hitched to the DIN rail comes out of this rail, then fold the top of the
router away from the DIN rail.
Figure 26: Default position of DIN holder
Figure 27: Removal of the DIN rail
15
SmartFlex SR307
230 V/50 Hz or 120 V/60 Hz.