Power Connector Pwr; Power Connector; Connection Of Power Supply; Connection Of Power Connector - Advantech SmartFlex SR307 User Manual

5.8.2 Power connector PWR

Panel socket 2-pin.
Pin number Signal mark
1 GND(-)
2 VCC(+)
The power supply for the router must be between +10 V to +60 V DC supply. Protection
against reversed polarity without signaling is built into the router. Note: The protection against
reversed polarity is lost if the negative pole is grounded!
The router can be put into low power mode using a special command lpm. It can then be
awakened, for example, by an activity on binary input or using an internal timer.
Circuit example:
Note for PoE: See Chapter
impact the power supply usage. The power supply for a PoE PSE router has to meet
other specific requirements.
Description
Negative pole of DC supply voltage
Positive pole of DC supply voltage (+10 to +60 V DC)
Table 10: Connection of power connector
Figure 29: Power connector
Figure 30: Connection of power supply
5.8.7 for information on how PoE versions of the router
18
SmartFlex SR307