Table of Contents
Advertisement
Eaton's Cooper Power series products meet or exceed all applicable industry standards relating to product safety. We
actively promote safe practices in the use and maintenance of our products through our service literature, instructional
training programs, and the continuous efforts of all Eaton employees involved in product design, manufacture, marketing
and service.
We strongly urge that you always follow all locally approved safety procedures and safety instructions when working around
high-voltage lines and equipment and support our "Safety For Life" mission.
The instructions in this manual are not intended as a
substitute for proper training or adequate experience in the
safe operation of the equipment described. Only competent
technicians who are familiar with this equipment should
install, operate, and service it.
A competent technician has these qualifications:
• Is thoroughly familiar with these instructions.
• Is trained in industry-accepted high- and low-voltage safe
operating practices and procedures.
• Is trained and authorized to energize, de-energize, clear,
and ground power distribution equipment.
• Is trained in the care and use of protective equipment
such as flash clothing, safety glasses, face shield, hard
hat, rubber gloves, hotstick, etc.
Following is important safety information. For safe
installation and operation of this equipment, be sure to read
and understand all cautions and warnings.
Hazard Statement Definitions
This manual may contain four types of hazard statements:
DANGER
Indicates an imminently hazardous situation which, if
not avoided, will result in death or serious injury .
WARNING
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury .
CAUTION
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury .
CAUTION
Indicates a potentially hazardous situation which, if not
avoided, may result in equipment damage only .
SAFETY
Safety for life
FOR LIFE
Safety information
Safety instructions
Following are general caution and warning statements that
apply to this equipment. Additional statements, related to
specific tasks and procedures, are located throughout
the manual.
Hazardous voltage . Contact with high voltage will
cause death or severe personal injury . Follow all locally
approved safety procedures when working around
high- and low-voltage lines and equipment .
Before installing, operating, maintaining, or testing this
equipment, carefully read and understand the contents
of this manual . Improper operation, handling, or
maintenance can result in death, severe personal injury,
and equipment damage .
This equipment is not intended to protect human
life . Follow all locally approved procedures and safety
practices when installing or operating this equipment .
Failure to comply may result in death, severe personal
injury, and equipment damage .
Power distribution and transmission equipment must be
selected for the intended application . It must be installed
and serviced by competent personnel who have been
trained and understand proper safety procedures . These
instructions are written for such personnel and are not
a substitute for adequate training and experience in
safety procedures . Failure to properly select, install or
maintain power distribution and transmission equipment
can result in death, severe personal
injury, and equipment damage .
INSTALLATION INSTRUCTIONS MN650048EN May 2017
SAFETY
FOR LIFE
DANGER
WARNING
WARNING
WARNING
G103 .3
G101 .0
G102 .1
G122 .3
iii
Advertisement
Table of Contents
