DeVilbiss IntelliPAP series Manual

D V I
e ilbiss ntelliPAP
DeVilbiss IntelliPAP series devices can be connected directly to the
pigtail cord and appropriate connector tip included in the Freedom
devices will require the use of the 150W sine wave power inverter in conjunction with the Freedom
Kit to complete the connection between the PAP device and the battery.
REQUIRED COMPONENTS
TM
Freedom CPAP Battery Kit

CONNECTION INSTRUCTIONS
Plug the DC power pigtail cord into the DC OUT jack of the battery.

Insert the connector tip with blue top labeled "J" into the DC power pigtail cord.

Plug the DC power pigtail cord with "J" connector tip attached into the DC input port of the PAP device.

Turn the PAP device on and it should begin functioning.

The digital display screen will show the charge level of the battery. You may press the charge level indicator

button to illuminate this screen. It will stay illuminated for a few seconds at a time.
When not in use disconnect all devices from the battery thus allowing the battery to completely shut down.

TM
OPTIONAL FREEDOM
     Auto Charge DC Cable {BPS DC.CABLE}: Used to charge the battery in a vehicle (vehicle must be running).
150W Sine Wave Power Inverter {BPS 150 INVERTER}: Used to charge the battery in a vehicle (vehicle does not need to
    
be running) and allows the battery to power/charge other small electronic devices.
     SunPower 40W Solar Panel {BPS SP40}: Used to charge the battery using the power of the sun.
S
eries: Single Battery
CONNECTOR TIP INSERTED
INTO PAP DC INPUT PORT
CPAP BATTERY CHARGING ACCESSORIES
BATTERY POWER SOLUTIONS
C
onnection
TM
Freedom
TM
CPAP Battery Kit. Please note IntelliPAP 2 series
DC OUT JACK
CPAP Battery using the DC power
TM CPAP Battery
DC POWER PIGTAIL CORD
Page 1 of 2 February 2017