DeVilbiss IntelliPAP Standard Quick Setup Manual

Menu Item Description
Clinical Menu
Language Select device language.
Selection
Set Set to CPAP pressure prescribed by doctor.
Pressure Range: 3-20 cmH
Delay Select period of time to stay at delay pressure. This delay is patient activated.
Time Range: 0-45 minutes, increments of 5
Delay If prescribed, set to a level that is comfortable for the patient to fall asleep. This level of pressure is maintained
Pressure for the first portion of the delay time and rises to the set pressure in the last 10 minutes of the delay time.
Range: 3 cmH
Pressure The device operating pressure may be displayed in one of three pressure units: cmH
Unit
Compliance Cumulative hours of "while breathing" time.
Meter
Enable Press the  button to enter. Reference the Enable Submenu section for details.
Menu
Lockout Press the  button to enter. Reference the Lockout Submenu section for details.
Menu
Enable Submenu
Auto-ON This option controls the Auto-ON feature, which automatically starts the flow of air after breathing once or
twice into the mask
Auto-OFF This option controls the Auto-OFF feature, which automatically stops the flow of air after taking off the mask. Disabled
Notifications Setting to enable mask/filter check notification.
Exit
Press the  button to exit and return to Clinical Menu.
Submenu
Lockout Submenu
Delay Time
Used to allow patient access to CPAP delay time setting.
Lockout Range: Locked, Unlocked
Exit Press the  button to exit and return to Clinical Menu.
Submenu

Other Settings

• Filter Cleaning Reminder – Displays a reminder to the patient to clean the filter every 50 hours of use, or approximately every 10 days. This
feature is controlled by the notifications setting and is preset to enabled.

Other setup information

• This device features automatic altitude adjustment for altitudes up to 2743m (9000ft) and needs no manual adjustment.
• This device features a pressure sensor therefore no fine pressure adjustments are needed.
• The SmartLink Data Management System may be used for additional reminders and notifications.
• Clear compliance meter by pressing Down key for eight seconds with compliance meter shown (value will go to zero).
All device settings are immediately updated in the device as you make adjustments. When finished press the ON/OFF button once to exit the
Clinical Setup Menu.
Sunrise Medical Ltd. • Sunrise Business Park • High Street • Wollaston, West Midlands • DY8 4PS • England • 44-138-444-6688
IntelliPAP™ Standard • SleepCube™ Standard
IMPORTANT! Do not provide these setup instructions to the patient. Only qualified
medical professionals should access these device settings.
Follow these instructions to access the device settings and prepare the device for
patient use. All settings have pre-set values as shown below.
First - With the device powered
and turned off, press and hold
the DOWN and DELAY
Second - While holding the
two buttons, press the
button. The display will show
"Clinical Menu". You can now
access the Clinical Setup Menu.
O
2
O to CPAP , increments of 0.5
2
DeVilbiss Healthcare • 100 DeVilbiss Drive • Somerset, PA 15501 • USA • 800-338-1988 • 814-443-4881
Quick Set-Up Guide
buttons.
ON/OFF
Use the LEFT
and RIGHT
navigate through the
menu.
Use the UP
DOWN button to adjust
the settings.
Factory
Default
English
10.0 cmH
20 min
4.0 cmH
O, hPa or mbar. cmH
2
N/A
N/A
N/A
Enabled
Enabled
N/A
Unlocked
N/A
©2007 DeVilbiss Healthcare 12.07
EN
button
button to
button and
0
2
0
2
0
2
DV51D-125 Rev. A