Assembly Instructions for Joining Back to Chair
Stellar Comfort Models
72
Step1: Plug in chair.
Step 2: Press the recline button on the hand control
until the footrest is about parallel to the floor. This
will expose the back brackets at the rear of the
chair.
Step 3: Slide the back down between the brackets
until the threaded studs on the back slip thru the
holes in the brackets as shown.
Step 4: Thread the flange lock nuts, located in the
arm cover bag, onto the studs and tighten securely
using the supplied wrench or a 7/16" box wrench.
Step 5: Remove the clevis pin from the back recline
motor tip. Slide the motor tip onto the back recline
bar. Insert clevis pin through the hole in the tip and
bar. Insert hair pin into the hole at the end of the
clevis pin as shown.
Step 6: Return the chair to the seated upright
position by pressing the sit button on the hand
control.
Step 7: Attach the bottom of the outside back to the
Velcro on the arm cross rail.