Back Installation - ultracomfort UC214 Service Manual

Assembly Instructions for Joining Back to Chair
Step1: Plug in chair.
Step 2: Press the down arrow on the hand
control until the footrest is about parallel to the
floor. This will expose the back brackets at the
rear of the chair.
Step 3: Slide the back down between the
brackets until the threaded studs on the back
slip thru the holes in the brackets as shown.
Step 4: Thread the flange lock nuts, located in
the arm cover bag, onto the studs and tighten
securely using the supplied wrench or a 7/16"
box wrench.
Step 5: Return the chair to the seated upright
position by pressing the up arrow on the hand
control.
Step 6: Attach the bottom of the outside back
to the Velcro on the arm cross rail.
71