LM5124 LIFT FRAME - CONTROL BOX - CONTINUED
Fig 2
Fig 3
Step 2 - Route the hand control coiled extension
along the right-hand side inside rail. Use 8"
black Ty wrap (BB5518) in two (2) places on the
lower rail. First, in front of the upright, and
second in front of the cradle motor as shown.
Next, loop the extension back and use one (1) 8"
black Ty wrap (BB5518) to the upper rail as
shown. Lay the loose end on the extension over
top of the upper rail as shown. Fig 2
For use in model: UC558-MLA
66
Step 3 - Attach the power cable
(GM2100-CB-EXT) and the motor 3-way
cable (GMC3M-3MEC) to the control box.
Attached the 1" black elastic cable hanger to
the U-bar and place the motor cables it the
hanger as shown.
NOTE: These cables MUST be suspended
inside the elastic hanger, and the ease
locks MUST be on the control box side of
the hanger as shown. Fig 3.