NETGEAR CG2003D User Manual page 42

To view or change LAN IP settings:
Select Advanced > LAN IP. The LAN IP screen displays.
1.
Enter the following LAN IP settings:
2.
LAN IP Address. Enter the LAN IP address that you would like to assign for your
•
gateway in dotted decimal notation. The factory default settings is 192.168.0.1.
Subnet Mask. Enter the network number portion of an IP address. Unless you are
•
implementing subnetting, use 255.255.255.0 as the subnet mask.
DHCP Server. The gateway is set up by default as a Dynamic Host Configuration
•
Protocol (DHCP) server, which provides the TCP/IP configuration for all the
computers that are connected to the gateway. You can change the default setting.
Yes. Select this settings to enable the DHCP server on the gateway and assign IP
-
addresses to computers on your LAN automatically.
No. Select this settings to assign IP addresses manually, or if you have another
-
DHCP server on your network.
If you disable the DHCP server, you will need to assign to your PC a static IP address
to reconnect to the gateway and enable the DHCP server again.
Starting IP Address. Complete the first of the contiguous addresses in the IP
•
address pool. 192.168.0.10 is the default start address.
Ending IP Address. Complete the last of the contiguous addresses in the IP address
•
pool. 192.168.0.19 is the default end address.
Click Apply to save your LAN IP settings.
3.
42 | Chapter 5. Advanced Settings
Wireless Cable Modem Gateway CG2003D User Manual