NETGEAR CG2003D User Manual page 17

Wireless Cable Modem Gateway CG2003D User Manual
Click the Setup Access List button to display the Wireless Card Access List screen.
2.
By default, the Access List table is empty. You need to add wireless devices here so that
they will have access to the wireless network when the list is enabled.
Adjust the access list as needed for your network. You can add devices to the access list
3.
using either of the following methods:
If the computer is in the Connected Wireless Devices table, click the radio button of
•
that computer to capture its MAC address. Then click Add.
Enter the MAC address of the device in the Add Access Filter fields. The MAC
•
address can usually be found on the bottom of the wireless device. Then click Add
If no device name displays when you enter the MAC address, you
Note:
can type a descriptive name for the computer that you are adding.
Click Apply to save these settings. Now, only devices in the Access List table are allowed to
4.
wirelessly connect to the gateway.
Security Options Settings
The Security Options section of the Wireless Settings screen lets you change the security
option and passphrase. The primary network for your gateway is already set up with WPA2
and WPA security. NETGEAR recommends that you set up wireless security for each guest
network that you plan to use.For information about changing these settings, see the following
section,
Change the WPA Security Option and Pre-Shared Key
Encryption and Passphrase
on page 19.
on page 18and
Set WEP
Chapter 2. Wireless Settings
.
| 17