Run The Diagnostic Ping Utility - NETGEAR CG2003D User Manual

Wireless Cable Modem Gateway CG2003D User Manual
Select Maintenance > Event Log. The Event Log screen displays.
1.
To clear the log, click Clear Log; to refresh the log, click Refresh. You can enable email
notification to receive these logs in an e-mail message. For information about email
notifications, see

Run the Diagnostic Ping Utility

You can use the Diagnostics screen to test connectivity to a PC using the ping command.
To start a ping test:
Select Maintenance > Diagnostics. The Diagnostics screen displays.
1.
Under Ping Test Parameters, enter the following settings:
2.
Target. Enter the IP address of the computer that you would like to ping.
•
Ping Size. Enter the size of the ping packet.
•
on page 24.
Logs
Chapter 4. Managing Your Network | 37