Advertisement
My Dreamhouse Instructions - Assembly
□
4. Turn the assembly over.
Glue and tape the other Side to the assembly.
□
5. Inspect the joints and tighten if necessary... these photos
show one good way to hold a joint tight while the glue dries -
Once the glue is dry the shape will be permanent.
A A
Inspect for looseness in the joint
Inspect for looseness in the joint
B
Side
Side
Side
Side
Floor
Floor
A piece of Trim sitting on the Floor
only, not overlapping the Side
Let the glue dry.
Note: Many of these photos are of a temporary build
(tape only) and the tape stayed on throughout the build,
but you should take your tape off when the glue is dry.
Step 4
p 4
C
Floor
Floor
Tape the Trim so it won't slip, Press the
looseness tight, then pull a strap of tape
fi rmly to hold it there - rub it down.
page 5
Stabilize
Stabilize
Pull
Pull
Advertisement
