Advertisement
My Dreamhouse Instructions - Painting, sanding, and cleaning
Assembly:
Continue to step 5 without stopping
Note: Many of these photos are of un-painted parts,
but you should have painted these parts at least one-
coat already, and have sanded thoroughly.
□
1. Glue and tape the Floor to the Back
e and tape the Floor to the Back
with the painted face to the inside.
ainted face to the inside.
Step 1
Back
Back
Taping:
Use enough tape so you can stick it down and still
have length enough to stretch the tape on both sides of the
joint... then rub the tape down for good adhesion.
□
2. Glue and tape the Ceiling Liner to the Back.
The Electrifi cation Slots in the Ceiling Liner allow ceiling-light in-
stallation above the ceiling (which some builders prefer)... you can
decide where the slots go or ignore them if you aren't going to wire.
□
3. The Sides are Left or Right - pick the one for
the end of the assembly that is up.
Glue and tape a Side to the assembly, tight in the back groove.
Side
Side
Inside
Electrifi cation Slots in the Floor make it easy to run tapewire through-
out your build, and multiple slots allow a choice in how you are wiring.
I usually put the slots forward to feed lights behind the Floor Trim but
Floor
Floor
your plan may be different. Plan ahead, then do it your way!
The narrow groove
The narrow groove
is the top
is the top
Use enough glue so some squeezes out of every joint.
Use enough glue so some squeezes out of every joint.
Keep a damp rag and a dry rag handy to clean up excess.
Keep a damp rag and a dry rag handy to clean up excess.
Step 2
Electrifi cation Slot
Electrifi cation Slot
Step 3
Floor
Floor
Ceiling Liner
Ceiling Liner
T T
Tight
Pull the Side to the back to make
Pull the Side to the back to make
it tight in the groove as you tape
it tight in the groove as you tape
page 4
See page 9
Advertisement
