Operating The Chiller Control Panel; Setting The Temperature; Setting Blower Speed; Displaying The Chilled Water Temperature - Webasto BlueCool C-Series Operating Instructions Manual

Operating the Chiller control panel

When the air-conditioning system is connected with the electrical power, the system initializes
itself. The display shows
Starting
Press once the
On is displayed and after appr. 5 sec. the current room temperature, e.g.

Setting the temperature

With the buttons
displayed.
e.g. room temperature 25 °C
Set temperature = 20 °C, Cooling mode starts.
Set temperature = 29 °C, Heating mode starts.
Attention: Only the mode that is preselected by the digital Chiller control panel can
be started.

Setting blower speed

Press the button
(blower speed 5)
• Value range (blower speeds):
• Factory Setting:
Set value with the buttons
 In the automatic blower speed mode
the temperature.
It can take some time before the blower starts.

Displaying the chilled water temperature

Press the button until
Check if the current operation mode is functioning properly.
 Cooling mode (LED snow flake) =Chilled water temperature drops constantly
 Heating mode (LED sun)

Access to further program levels

Press the button until
be modified (by the installer).
Further information can be found in the Installation Instructions.
Init and afterwards the frequency, e.g.
button.
and between 15 °C and 29 °C while the room temperature is
until b is shown to the left and the selected value to the right, e.g.
1-2-3-4-5
A (Automatic blower speed)
and
E is shown to the left and a numerical value to the right, e.g. E10.5.
code is displayed. With a special access code specific settings can
and A
. Your setting is secured.
(b A) the blower start and operation depends on
=Chilled water temperature rises constantly
3
50 Hz.
28.5 (°C) is shown.
b 05