Digital Cabin Control Panel - Webasto BlueCool C-Series Operating Instructions Manual

• Switching the Chiller unit on and off
• Programming and setup of the Chiller unit
• Setup of directly connected air handlers
• Selection of operation mode (Automatic, Cooling, Heating)
• Switching the Chiller unit on and off
• Programming and setup of the Chiller unit
• Setup of directly connected air handlers
• Selection of operation mode (Automatic, Cooling, Heating)

Digital cabin control panel:

• Start and stop of indirectly connected air handlers
• Temperature and blower setting for indirectly connected air handlers
The operation mode can not be selected with the cabin control panel!
Digital Chiller control panel for Chiller units and
directly connected air handlers
The digital Chiller control panel ist factory pre-programmed. The secondary commands are
code-protected.
• If your Chiller unit has a heating option, the cabins can be heated until the sea water
temperature drops below 6 °C.
The function „Automatic with reverse heating operation" (F3)
• If an external water heater is integrated in your chilled water air-conditioning system, you
can heat independently from the sea water temperature (See installation instructions for
external heater).
The function „Automatic with external heater" (F4)
Cooling mode
Automatic mode
Heating mode
On / Off
Set-up / programming
Cool
Auto
Heat
Blower speed
2
is pre-set.
is pre-set.
Lower values
Read-out
Higher
values