Starting And Operating Your Vehicle; Ignition Positions; New Vehicle Break-In - Saturn 2009 OUTLOOK Owner's Manual

2-20 Features and Controls
Starting and
Operating Your
Vehicle

New Vehicle Break-In

Notice: The vehicle does
not need an elaborate break-in.
But it will perform better in
the long run if you follow these
guidelines:
•
If you have all-wheel drive,
keep your speed at 55 mph
(88 km/h) or less for the
first 500 miles (805 km).
•
Do not drive at any one
constant speed, fast or slow,
for the first 500 miles (805 km).
Do not make full-throttle
starts. Avoid downshifting to
brake or slow the vehicle.
•
Avoid making hard stops for
the first 200 miles (322 km)
or so. During this time the
new brake linings are not yet
broken in. Hard stops with new
linings can mean premature
wear and earlier replacement.
Follow this breaking-in
guideline every time you get
new brake linings.
•
Do not tow a trailer during
break-in. See Towing a
Trailer on page 4-26 for the
trailer towing capabilities
of your vehicle and more
information.
Following break-in, engine speed
and load can be gradually
increased.

Ignition Positions

The ignition switch has four different
positions.
In order to shift out of P (Park),
the ignition must be in ON/RUN or
ACC/ACCESSORY and the
brake pedal must be applied.
Notice: Using a tool to force the
key to turn in the ignition could
cause damage to the switch or
break the key. Use the correct key,
make sure it is all the way in, and
turn it only with your hand. If the
key cannot be turned by hand,
see your dealer/retailer.