Windshield Washer - Saturn 2009 OUTLOOK Owner's Manual

3-8 Instrument Panel

Windshield Washer

J (Washer Fluid): Press the
button located at the end of the
turn signal/multifunction lever, to
spray washer fluid on the windshield.
The wipers clear the windshield and
either stop or return to the preset
speed. The ignition key must be in
ACC/ACCESSORY or ON/RUN for
this to work. See Windshield Washer
Fluid on page 5-26 Windshield
Washer Fluid.
{
CAUTION
In freezing weather, do not use
your washer until the windshield is
warmed. Otherwise the washer
fluid can form ice on the
windshield, blocking your vision.
WASHER FLUID LOW ADD FLUID
is displayed on the Driver Information
Center (DIC) when the washer fluid
is low. See DIC Warnings and
Messages on page 3-56.
Heated Windshield Washer
For vehicles with the heated
windshield washer fluid system,
it helps to clear ice, snow, tree sap,
or bugs from the windshield. This
feature only works with the front
wiper system.
The button is located to the left
of the steering column below the
instrument panel brightness
control knob.
Press the heated washer fluid button
to activate the heated windshield
washer fluid system. This activation
begins four heated wash/wipe
cycles. The first heated wash/wipe
cycle can take up to 40 seconds
to occur, depending on outside
temperature. After the first wash/
wipe cycle, it can take up to
20 seconds for each of the remaining
cycles. The system turns off
automatically after four wipe cycles
or the button can be pressed again to
turn it off.
Under certain outside temperature
conditions, steam might flow out
of the washer nozzles for a short
period of time before washer fluid
is sprayed. This is normal.
HEATING WASH FLUID WASH
WIPES PENDING is displayed on
the DIC when the washer system is
heating the fluid. WASHER FLUID
LOW ADD FLUID is displayed when
the washer fluid is low. See DIC
Warnings and Messages on
page 3-56.