Saturn 2009 OUTLOOK Owner's Manual page 231

Making a Call
Calls can be made using the
following commands:
•
Dial
•
Digit Dial
•
Call
•
Re-dial
Using the Dial Command
b g
1. Press and hold
two seconds. The system
responds with "Ready"
followed by a tone.
2. Say "Dial". The system responds
with "Dial using <phone name>.
"Number please" followed by
a tone.
3. Say the entire number without
pausing.
•
If the system recognizes the
number, it responds with
"OK, Dialing" and dials
the number.
•
If the system does not
recognize the number, it
confirms the numbers followed
by a tone. If the number is
correct, say "Yes". The system
for
responds with "OK, Dialing"
and dials the number. If the
number is not correct, say
"No". The system will ask for
the number to be re-entered.
Using the Digit Dial Command
1. Press and hold
two seconds. The system
responds with "Ready"
followed by a tone.
Instrument Panel
2. Say "Digit Dial". The system
3. Say the digit to be dialed one
4. Continue entering digits until the
b g
for
responds with "Digit dial using
<phone name>, please say the
first digit to dial" followed by
a tone.
at a time. Following each digit, the
system will repeat back the digit it
heard followed by a tone.
number to be dialed is complete.
After the whole number has been
entered, say "Dial". The system
responds with "OK, Dialing" and
dials the number.
•
If an unwanted number is
recognized by the system,
say "Clear" at any time to
clear the last number.
•
To hear all of the numbers
recognized by the system, say
"Verify" at any time and the
system will repeat them.
3-109