Starting And Operating Your Vehicle; New Vehicle Break-In - Saturn 2009 AURA Owner's Manual

To program the new key:
1. Verify that the new key has a
2. Insert the already programmed key in the ignition
and start the engine. If the engine will not start,
see your dealer/retailer for service.
3. After the engine has started, turn the key to
LOCK/OFF, and remove the key.
4. Insert the key to be programmed and turn it to the
ON/RUN position within five seconds of the original
key being turned to the LOCK/OFF position.
The security light will turn off once the key has
been programmed.
5. Repeat Steps 1 through 4 if additional keys are to
be programmed.
If you are ever driving and the security light comes on
and stays on, you may be able to restart your engine if
you turn it off. Your PASS-Key
is not working properly and must be serviced by your
dealer/retailer. Your vehicle is not protected by the
®
PASS-Key III+ system at this time.
®
If the PASS-Key III+ key is lost or damaged,
see your dealer/retailer or a locksmith who can
®
service PASS-Key III+ to have a new key made.
Do not leave the key or device that disarms or
deactivates the theft deterrent system in the vehicle.
1
stamped on it.
®
III+ system, however,
Starting and Operating Your
Vehicle

New Vehicle Break-In

Notice: The vehicle does not need an elaborate
break-in. But it will perform better in the long run
if you follow these guidelines:
•
Do not drive at any one constant speed, fast
or slow, for the first 500 miles (805 km).
Do not make full-throttle starts. Avoid
downshifting to brake or slow the vehicle.
•
Avoid making hard stops for the first 200 miles
(322 km) or so. During this time the new brake
linings are not yet broken in. Hard stops with
new linings can mean premature wear and earlier
replacement. Follow this breaking-in guideline
every time you get new brake linings.
•
Do not tow a trailer during break-in. See Towing
a Trailer on page 4-30 for the trailer towing
capabilities of your vehicle and more
information.
Following break-in, engine speed and load can be
gradually increased.
2-21