Cables And Modules; Cable Installation - Mellanox Technologies ConnectX-5 Ex User Manual

5. When the adapter is properly seated, the port connectors are aligned with the slot opening,
and the adapter faceplate is visible against the system chassis.
Secure the adapter with the adapter clip or screw
3.6

Cables and Modules

To obtain the list of supported Mellanox cables for your adapter, please refer to the
ence Table.

3.6.1 Cable Installation

1. All cables can be inserted or removed with the unit powered on.
2. To insert a cable, press the connector into the port receptacle until the connector is firmly
seated.
a. Support the weight of the cable before connecting the cable to the adapter card. Do this by using a cable
holder or tying the cable to the rack.
b. Determine the correct orientation of the connector to the card before inserting the connector. Do not try and
insert the connector upside down. This may damage the adapter card.
c. Insert the connector into the adapter card. Be careful to insert the connector straight into the cage. Do not
apply any torque, up or down, to the connector cage in the adapter card.
d. Make sure that the connector locks in place.
Rev 1.7
When installing cables make sure that the latches engage.
Always install and remove cables by pushing or pulling the cable and connector in a
straight line with the card.
Mellanox Technologies
Hardware Installation
Cables Refer-
23