3.1.3 Software Requirements
3.1.3.1 Operating Systems/Distributions
Please refer to
3.1.3.2 Software Stacks
Mellanox OpenFabric software package MLNX_OFED for Linux, and WinOF-2 for Windows
and VMware. See
3.2
Safety Precautions
1. Remove any metallic objects from your hands and wrists.
2. Make sure to use only insulated tools.
3. Verify that the system is powered off and is unplugged.
4. It is strongly recommended to use an ESD strap or other antistatic devices.
3.3
Pre-Installation Checklist
1. Unpack the ConnectX-5 adapter card
Unpack and remove the ConnectX-5 card. Check against the package contents list that all the
parts have been sent. Check the parts for visible damage that may have occurred during ship-
ping. Please note that the cards must be placed on an antistatic surface. For package contents
please refer to
Rev 1.7
Direction
Section 1.4, "Operating Systems/Distributions", on page
Chapter 4, "Driver Installation"
The adapter is being installed in a system that operates with voltages that can be lethal.
Before opening the case of the system, observe the following precautions to avoid injury and
prevent damage to system components.
Section 1.2, "Package Content", on page 12.
Mellanox Technologies
Description
From the network ports to the heat-
sink
14.
.
Hardware Installation
19