Connections; Basic Connections - Sanyo NETWORK CAMERA VCC-WB4000P Instruction Manual

Connections

Turn off the power for all equipment before making any connections.

Basic Connections

1
Connect the camera to a computer.
Connect a cable between the ETHERNET connectors of the camera and the computer.
Use a crossed wire-type Ethernet cable.
2
Connect the power supply.
After connecting the power supply, install the supplied ferrite core A to the power cord.
If using a commercially-available 24 V AC adapter, always be sure to connect the ground wire
(18AWG or higher) to the ground terminal. (Figure 1)
If using a 12 V DC power supply (sold separately: DSA-0151CD-12J), make the connections as
shown in Figure 2.
Note:
In order to avoid any problems with the camera and the power supply, take sufficient care to
ensure that the polarities are correct when connecting the power supply.
When the accessory ferrite cores are attached, they will increase the load on the cable, so after
doing the installation, adjust the cable accordingly.
3
Insert the power cord plug into a wall outlet.
The POWER indicator will illuminate.
Computer
Ethernet cable
(crossed wire-type cable)
English
1
3
24 V AC connection
3
Figure 1
MONITOR
ETHERNET
OUT
AC24V
COM
PC
POWER
1 2
MODEM
CLASS 2 WIRING
DC12V
ALARM IN OUT
AC24V GND
2
DC12V
– 9 –
PC CARD
RS-232C
GND
12 V DC connection
3
Figure 2
A
AC24V GND
DC12V
2