Sanyo NETWORK CAMERA VCC-WB4000P Instruction Manual page 48

Recording and Deleting Alarm Images
(3) Recording of alarm data into the
internal memory is complete
Once this happens, the recorded data can
then be played back.
Note:
The display screen in (3) shows that the
alarm recording area is full and overwriting is
set to "OFF".
At times other than this, the ALARM indicator
will illuminate orange.
Settings such as the image size cannot be
changed during pre-alarm recording.
English
(Red or green)
– 47 –
Fixed Settings During Pre/Post-Alarm
Recording
If the pre-alarm/post-alarm recording area ratio
is set to something from 10%/90% to 50%/50%
so that pre-alarm recording can be carried out,
the transmission settings are fixed.
Example 1: If "PRIORITY" is set to "PICTURE
QUALITY"
The image quality during pre- and post-alarm
recording will be fixed at "HIGH".
Example 2: If "PRIORITY" is set to
"RECORDING RATE"
The image quality during pre- and post-alarm
recording will be fixed at "MID1".
When alarm data is recorded into the camera's
internal memory, the settings that are fixed
during pre- and post-alarm recording will be
canceled. However, if a memory card is inserted,
the settings will be fixed until the recording area
becomes full.
Fixed
Fixed