Intermediate Storage - Boge C 15 Operating Instructions Manual

Installation

Intermediate storage

Page 24
3.1
Crane transport
WARNING!
Inappropriate transport may lead to compressor damages. Do not subject the
safety cladding to force during transport.
– Protect the compressor using wooden spacers (see arrows in the follow-
ing illustration).
– Remove transport timbers.
– Only use suitable transport slings having a minimum length of approx.
120 inches!
Fig. 3.2: Crane transport
In case the compressor is not installed immediately after delivery, it has to be
stored at a sheltered location. It must be ensured that during the intermediate
storage neither dust nor humidity can penetrate.
NOTICE!
In case of an intermediate storage please observe the specifications and di-
rections as to permissible environmental impacts (see chapter „3.2 Com-
pressor room: Installation conditions for separately arranged compressed air
receivers").
In case of a careless storage we assume no liability for consequent dam-
ages!
In the event of an extended intermediate storage or after an extended stand-
still (six months) you should consult BOGE-Service.
Please observe the directions for commissioning after an extended standstill
(see chapter „3.5 Commissioning") if the intermediate storage takes longer
than two months.
Transport and storage
Position the slings at the ends underneath
the base frame of the compressor.
Neither fasten the transport slings to the
suction filter nor to the eyelet on the motor.
BOGE Operating instructions for C 15 series screw compressors