2.19 ELECTRONIC CONTROL SYSTEM
Hand Held Analyzer
Analyzer Display
Escape Key
To return home or access previ-
ous menu
Up & Down Arrow Keys
Value Selector
To Connect the Hand Held Analyzer
1. Connect the four pin end of the cable supplied with the
analyzer, to the top connection of the motor controller
and connect the remaining end of the cable to the ana-
lyzer.
NOTE: The cable has a four pin connector at each end of the cable;
the cable cannot be connected backwards.
2. Power up the Control System by turning the lower key to
the platform position and pulling both emergency stop
buttons on.
3121801
m en u:
HELP:
PRESS ENTER
Figure 2-29. Hand Held Analyzer
SECTION 2 - PROCEDURES
Enter Key
Stores and selects Top Level, Sub Level,
and item menus
Left & Right Arrow Keys
Used to move between Top Level, Sub
Level, and item menus
2-31