Pc Control Codes And Cable Connections; Functional Execution Command Table - Sanyo PDG-DXT10KL User Manual

PC Control Codes and Cable Connections

This projector provides a function to control and monitor the projector's operations by using the RS-232C serial port.
1.
Connect a RS-232C serial cross cable to
SERIAL PORT IN on the projector and serial
port on the PC.
2.
Launch a communication software provided
with PC and setup the communication condi-
tion as follows:
Baud rate
Parity check : none
Stop bit
Flow control : none
Data bit
3.
Type the command for controlling the projec-
tor and then enter the "Enter" key.
Example
When you want to change the input to Computer 2, Type "C" "0" "6" "Enter."
The below table shows the typical command lists for controlling the projector. Please consult your local dealer for further
information of another commands.

Functional Execution Command Table

C
OMMAND
C00 Turn the projector ON
Turn the projector OFF
C01
(immediately OFF)
C05 Selects Computer 1
C06 Selects Computer 2
C07 Selects Computer 3
C08 Selects Component
C09 Volume UP
C0A Volume DOWN
C0B Audio mute ON
C0C Audio mute OFF
C0D Video mute ON
C0E Video mute OFF
C0F Aspect 4:3
C10 Aspect 16:9
C1C Menu ON
C1D Menu OFF
C33 Selects Video
C34 Selects S-video
: 38400 bps
: 1
: 8
F
UNCTION
115
C
OMMAND
C3A Pointer RIGHT
C3B Pointer LEFT
C3C Pointer UP
C3D Pointer DOWN
C3F Enter
C46 Zoom DOWN
C47 Zoom UP
C4A Focus DOWN
C4B Focus UP
C5D Lens shift UP
C5E Lens shift DOWN
C5F Lens shift LEFT
C60 Lens shift RIGHT
C89 Auto PC Adj.
C8E Keystone UP
C8F Keystone DOWN
C90 Keystone RIGHT
C91 Keystone LEFT
8. Specifications
F
UNCTION