Sanyo PDG-DXT10KL User Manual page 109

6. Maintenance
Check the lamp number to be replaced by using Information Menu.
Turn off the projector and disconnect the AC plug. Allow the projector to cool for at least 60 minutes.
1.
Loosen the screw on the lamp cover
(A), and remove the lamp cover as
shown (B).
2.
Loosen the two captive screws on
the lamp module (A). Lift the mod-
ule handle up as shown (B).
3.
Pull firmly on the module handle in
the direction shown to remove the
lamps.
4.
Reverse steps 1 to 3 to install the
new lamp module and replace the
lamp cover.
100