Sanyo PDG-DXT10KL User Manual page 93

5. Using On-Screen Display
I
TEM
Remote control
Message
Filter warning
Search mode
On start
On start enables the projector to start automatically when the power cable is connected to an active power outlet and the
main power switch is on. This eliminates the need to always use the POWER (On) button on the remote control or projec-
tor cabinet. To use the On start function, you must first press the main power switch to On before connecting the power
cable.
Note:
When the projector is off by using the POWER button (or put in the standby mode) and the power cable is
disconnected, On start will not activate after power (AC) is applied.
When the projector is off by using the Direct Power Off function or after the power (AC) is removed (no
standby mode), On start will be activated after power (AC) is applied.
The Direct Power Off function means you can turn off the power (AC) to the projector by using a power
strip equipped with a switch and a breaker.
Power management
Power management enables the projector to automatically turn off if there is no signal received by any input.
This option switches remote control codes.
Range: Code 1, Code 2, Code 3, Code 4, Code 5, Code 6, Code 7, Code 8
This option turns on or off messages.
Range: Off or On
Set this item to on to have the projector display a message when the air filter needs servicing.
Range: Off, 100[H], 200[H], 500[H], 1000[H]
This feature sets the Auto Adjust mode.
Range: Normal, Fine
D
ESCRIPTION
84