Table of Contents
Advertisement
Pump Mounting Instructions
2.3
Use the backplate as a
template to mark the position
of the mounting holes.
Fix pump to wall using No 8 screws. Use crimps supplied to terminate 24V d.v.
cable from transformer, connect to pump and feed cable through entry point.
Hold cable in place using adjacent cable bracket.
To remove cover, use two hands to push backplate clips together.
As clips disengage, the cover will fall forward and may be lifted away.
Use a 6 mm bit to drill holes
at marked points and insert
No 6 wall plugs.
7
Use pliers to open up desired cable entry
point on backplate. Don't use top centre
entry. X = DO NOT USE
To fit cover, locate bottom lug into
backplate, and pivot cover forward until
top clips click into place.
If the pump is misaligned on the backplate
or pump head is not parallel with backplate
the push-fit connectors may prevent the
front cover from fitting properly. Adjust
pump, pump head or connecting pipework
to achieve a good fit.
Use of elbows on pump inlet and outlet
should be avoided. If the situation demands
that they are used, ONLY use John Guest
push-fit elbows. Other types are not readily
demountable and may foul the cover.
Advertisement
Table of Contents
