Pump Set-Up - Mixer Shower 22Mm - Whale Digital Smoothflow Installation Manuallines

Pump Set up – Mixer Shower 22mm (3)
5. Pump shut down: Over Run (Auto-Sense) is
the preferred option. Auto-Sense stores the pump no load
current when air is drawn by the pump after water is removed
from the tray. Once set, when this value is reached the pump
will go into its shut down sequence.
O v e r - R u n
T y p e
Time Delay is the default setting. To set Auto Sense press
then press OK ' ' to select.
O v e r - R u n
T y p e
Turn off the shower. When the pump has removed the water
remaining in the tray the pump current will decrease. When it
has reached the lowest value (by observing when the value
stops falling) press OK ' '.
P u m p C u r r e n t
O K
Pump will run on for a few seconds before stopping
Over Run (Time-Delay)
This sets a fixed Over Run time that the pump continues to
run after the shower has been turned off.
O f f D e l a y
T i m e
Use or to select value of time delay (in seconds) and
press OK ' ' to store.
O K
T I M E - D E L A Y
O K
A U T O - S E N S E
8 6
0
O K
1 0 s e c
6. Start volume: This selects the initial amount of water (litres)
in the tray before pumping starts. To minimise noise the water
should be above the level of the gulley.
S t a r t D e l a y
V o l u m e
(Factory default is 0.6 ltrs, minimum setting). Pressing
increases the amount of water from 0.6 ltrs to 4 ltrs. Typical
value between 0.8 and 2 ltrs. Press OK '
7. Purge Cycle: When ON is selected the pump restarts 15
minutes after showering is completed.
P u r g e C y c l e
1 5 m i n C y c l e
This happens automatically to remove water that gathers as it
drains into the gulley . The pump runs at a low speed for less
than 30 seconds.
Press OK ' ' to select.
If desired the Purge Cycle may be disabled by pressing
and OK ' ' to select OFF.
Factory Default Settings
If part way through set-up and you wish to start again, turn
the unit off until the display fades, and then back on again.
The screen will display:-
System Type and Software level
S m o o t h f l o w
R e v i e w >
Press OK ' ' to begin again. The screen will start at language
options. See page 12.
17
O K
0 . 6 L t r s
' to select.
O K
O N
V 1 . 9
A d j u s t