Casio 5526 Operation Manual page 21

Alarm
Q1
The alarm does not sound.
Is the watch's battery charged?
Keep the watch exposed to light until it
recharges sufficiently.
Solar Charging
l
The crown is pulled out.
The alarm will not sound while the crown
is pulled out. Push the crown back in to its
normal position.
Is the alarm enabled?
Enable the alarm.
Enabling/Disabling the Alarm
l
Hand Movement and
Indications
Q1
I don't know what mode the watch is
in.
You can determine the current mode by
checking the mode hand position. Use (C) to
navigate between modes.
Navigating Between Modes
l
Q2
The second hand is jumping at two-
second intervals.
Battery power is low. Keep the watch exposed
to light until it recharges sufficiently.
Solar Charging
l
Q3
All hands are stopped and buttons do
not work.
The battery is dead. Keep the watch exposed
to light until it recharges sufficiently.
Solar Charging
l
Operation Guide 5526
Q4
The hands suddenly start moving at
high speed.
This is due to one of the reasons below, and
does not indicate malfunction. Simply wait
until normal hand movement resumes.
The watch is recovering from a power
●
saving state.
Power Saving
l
A time calibration signal is being received
●
and the time setting is being adjusted.
Time Adjustment (GPS, Time Calibration
l
Signal)
Watch is connected with a phone to adjust
●
its time setting.
Auto Time Adjustment
l
Q5
Hands are stopped and buttons do
not work.
The watch is in the charge recovery mode.
Wait until the recovery process is complete
(for about 15 minutes). The watch will recover
more quickly if you place it in a brightly lit
location.
Q6
Why is the current time indicated by
the watch is off by a large amount of
time (nine hours, three hours and 15
minutes, etc.)?
The city setting is not correct. Select the
correct setting.
Selecting Your Home City's Time Zone
l
Q7
The current time indicated by the
watch is off by one hour or 30
minutes.
The summer time setting is not correct. Select
the correct setting.
Selecting Your Home City's Time Zone
l
Q8
The hand and/or day indicator are not
aligned correctly.
Strong magnetism or impact can cause the
hands and/or the indicator to go out of
alignment. Adjust hand and/or day indicator
alignment.
Adjusting Hand and Day Indicator
l
Alignment
Check the information below to find out how
●
to align the hands and/or day indicator
manually.
Adjusting Hand and Day Indicator
l
Alignment
Crown Operations
Q1
Nothing happens when I rotate the
crown.
If you do not perform any operation for about
two minutes after pulling out the crown
(approximately 30 minutes in the case of hand
and day indicator alignment), crown
operations will automatically become
disabled. Push the crown back in to its normal
position and then pull it out again to re-enable
crown operations.
Using the Crown
l
21