Switching The Vibration On And Off - Bomag BW 100 AD-4 Operating Instructions Manual

Operation
Fig. 70
Set the throttle lever (Fig. 70) to position "MIN"
l
(idle speed).
Caution
!
Do not shut down the engine all of a sudden
from full load speed, but let it idle for about 2
minutes.
Fig. 71
Turn the start switch (Fig. 71) to position "0"
l
and pull out the ignition key.
Danger
!
Danger of accident!
Secure the machine against unauthorized use,
pull the ignition key out.
Mark machines, which could be in the way,
with a clearly visible sign.
54
5.10 Switching the vibration on
and off
Danger
!
Risk of damage!
When compacting with vibration you must
check the effect of nearby buildings and un-
derground supply lines (gas, water, sewage,
electric power), if necessary stop compaction
with vibration.
Caution
!
Danger of bearing damage!
Do not activate the vibration on hard (frozen,
concrete) ground.
Caution
!
Switch on vibration only with the throttle lever
in full load position "MAX I" or "MAX II".
Vibration at standstill causes transverse ruts,
therefore:
switch the vibration on only after shifting the
l
travel lever to the desired travel direction.
Switch the vibration off before stopping the
l
machine.
BOMAG BW 100/120/125 AD-4/AC-4